Camsco | Automatic Transfer Switches
1926
page-template-default,page,page-id-1926,page-parent,page-child,parent-pageid-1552,ajax_leftright,page_not_loaded,smooth_scroll,

Automatic Transfer Switches

   

Automatic Transfer Switches

 

Thank you for reading this post, don't forget to subscribe!

Camso is an automatic transfer switch manufacturers. Our automatic power transfer switches have reliable mechanical interlock, high arc-quenching performance and high transfer speed.

 W Series Dual-power Automatic Transfer Switches

  • The W Series belong to the PC level, and include the types of W2 and WN3. W-2 is a two-stage automatic transfer switch. After a switching signal is received the switch transfers power immediately from one source to the other without stopping at an OFF position in the middle. The rated current is 20A~500A.
  • The WN3 is a three-stage automatic transfer switch. After a switching signal is received the switch transfers power immediately, or after a preset delay, or stop at an OFF position in the middle. The rated current is 20A~5000A.

 Characteristics of ATS switches:

  • Reliable mechanical interlock: Special eccentric selection construction to ensure only one power source is connected.
  • High arc-quenching performance: Extinguishes abnormal electrical arcing, short duration of electric arcing and low contact loss.
  • Multi-disc main arc contract: Enhances the contact area and pressure of contact surfaces, eliminating overheating and contact welding and extending contact lifespan.
  • High Transfer speed: Rapid transfer between the active power and standby power, allowing a customized transfer delay for an ATS with a controller.
  • Simple construction and small volume: Have reliable operation, a low failure rate and are convenient to install and maintain. Allow rotation with a handle during repair for convenient error detection and troubleshooting. The ATS of the W series are at PC level, are smaller than those of CB level, but have a higher current rating.